Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16
www.aeg.com
10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pauze - Départ/
Pause to set the appliance to pause.
The related indicator flashes.
2. Press button Startuitstel - Départ
Différé repeatedly until the display
shows .
3. Press button Start/Pauze - Départ/
Pause again to start the programme
immediately.
10.10 Interrupting a
programme and changing a
option
You can change only some options
before they operate.
1. Press button Start/Pauze - Départ/
Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pauze -
Départ/Pause again.
The programme continues.
10.11 Cancelling a running
programme
1. Turn the programme knob to
cancel the programme.
2. Turn again the programme knob to a
new washing programme. At this
time you can also set the available
functions.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
you cannot open the door.
To open the door proceed as follows:
1. Press the button Aan/Uit - Marche/
Arrêt for some seconds to deactivate
the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
10.13 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Start/Pauze - Départ/
Pause.
In the display the door lock indicator
goes off.
to
2. Open the appliance door.
3. Close the door and press button
Start/Pauze - Départ/Pause.
The delay start continues.
10.14 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
locked indicator
The indicator of Start/Pauze - Départ/
Pause button goes off.
1. Press button Aan/Uit - Marche/Arrêt
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
stays on and
comes on and the door
goes off.
Werbung
