Tabernus Peram boot-bag Einbauanleitung

1. Open boot/trunk lid & lay straps out as shown in a 'H' then lower boot lid
2. Place the anti-slip matting towards the front of the boot/trunk lid (i.e. near to driver ensure the boot/trunk
lid is dry & clean
3. Lay the boot-bag on the matting making sure the flap/zip/logo is facing the back of the car
4.Then attach the 6 ends of the straps to H shape harness using the ladder-lock buckles ensure all pulled
tight (do not over tighten and strain fixing points & ensure H strap is in place when tightening sides) It is
essential that the flap covers the zip or the bag will not be waterproof
Your boot-bag is supplied with 3
straps 2 x 1.8m, 1 x 2.4m these can
be cut to suit your car, then use
lighter to melt the ends to stop any
fraying.
We advise you pull over after the first
5 – 10 Miles to pull straps tight if
needed as the contents of bag will
settle.
Installation of your boot-bag
!