FLYLINKTECH CF800 Bedienungsanleitung Seite 12

High temperature release
8
Starting Current
9
10 Start Overrun Protection
Start-up protection
11
12
Work instructions
13
Battery voltage detection
14
Starter adhesion failure alarm
55±5℃/131±10℉
When the temperature drops, it can return to the standby state.
1000A±10%
Lasts 1s
Emergency power supply voltage＜6.5V, continuously exceeding
Support 0.2S; voltage＜5V, continuously exceeding
0.02S; the protection is triggered, and the "
After the wire clamp is activated 8 times continuously, the protection
8 times
is triggered, and the symbol of "8 times activation times protection"
flashes
The current emergency start-up power battery voltage will be
Support
displayed when the wire clamp is turned on.
When the wire clip is only connected to the car battery (the car
battery voltage needs to be ≥8V) "
Support
current battery voltage is displayed at the same time.
When the clamp is powered on for the first time, if the
relay has adhesion failure, the "
Support
and the buzzer will beep for a long time.
9
" symbol flashes.
" symbol point on, the
" symbol will flash