Installation; Instruments With The Tekprobe Ii Interface; Instruments Without The Tekprobe Ii Interface - Tektronix P6701B Anleitung

Getting Started

Installation

Before you connect the output of the P6701B, P6703B, and P6723
O/E Converters, determine whether or not your instrument has the
TekProbe II interface (see Figure 2 on page 6).

Instruments with the TekProbe II Interface

For instruments that have the TekProbe II interface, simply connect
the converter to the oscilloscope input. The interface provides
connections for power, signal, and scale factor coding.
NOTE. TDS 400 and TDS 400A series oscilloscopes always interpret
the P6701B, P6703B, and P6723 attenuation setting as
display units as V instead of mW. When you use the O/E converters,
divide the measurement (or scale factor) by 10 and interpert
measurements as milliwatts instead of volts.

Instruments without the TekProbe II Interface

For instruments that do not have the TekProbe interface, order the
optional 1103 TekProbe Power Supply. Accessories are also
available to terminate the output into the required 50
12
P6701B, P6703B & P6723 Instructions
10 and