Vogue FS488 Bedienungsanleitung Seite 3

To Start Weighing:
Weighing mode
1. Place the scale on a solid and flat surface.
2. Place bowl (if used) on the scale before turning on the scale.
3. Gently press on the scale with your hand to turn on. Wait until LED shows '0'.
4. Press to convert to Weight mode.
5. Place items on the scale to start weighing, LED will show the weight reading.
Volume indication mode
1. Place the scale on a solid and flat surface.
2. Gently press on the scale with your hand to turn on. Wait until LED shows '0'.
3. Press to choose "Water" or "Milk" mode.
4. Put a liquid container on the scale platform. LED shows the weight of container.
5. Press to reset the reading to "0".
6. Pour liquid (water or milk) into the container. LED shows the volume of the liquid.
"ZERO" or "TARE" function
To weigh different loads consecutively without removing previous loads from the scale:
1. Put first Load on the scale and get weight reading.
2. Press to reset the reading to "0" before adding next load. You can repeat this operation.
Condition 1: "ZERO" function
When total sum of all loads on scale is ≤4% of scale's maximum weight capacity (4% here means 400g
with this scale), LED will show "-----" or "0 g" each time
"-----" means reading is not stable. Please wait for a moment. "0 g" and meanwhile an icon "O" on the
left side of LED indicate ZERO function is activated. In this case, maximum weight capacity remains
unchanged.
Condition 2: "TARE" function
When total sum of all loads on scale is >4% of scale's maximum weight capacity (4% here means 400g
with this scale), LED will show "-----" or "0 g" each time
"-----" means reading is not stable. Please wait for a moment. "0 g" and meanwhile an icon "T" on the left
side of LED indicate TARE function is activated. In this case, maximum weight capacity is reduced by total
weight of all loads.
Under this condition:
• By pressing , you can see the total weight of all loads on the scale.
• To weigh more loads, just press
FS488_ML_A5_v2_20230606.indb 3
is pressed.
is pressed.
to reset LED reading to '0' again.
EN
3
2023/6/6 19:32:45