Velleman VM120 Bedienungsanleitung Seite 8

Light effects
LIGHT EFFECTS
Choosing light effects :
The SW1 'Effect select' pushbutton switch allows you to choose between ten programs. Keep SW1 pressed to see the se-
lected effect – the LED corresponding to that effect will light up. The effect starts when you release SW1. Press SW1 briefly
to select the next effect.
SW2 allows you to (de)activate all channels at once. Press SW1 to restart the selected light effect.
The speed of the light effect can be adjusted with RV1.
The last selected effect is saved in the internal memory in case of a power failure.
Select a random light effect:
Keep SW2 pressed during power-up (the other light effects will not work!).
HINTS:
•
In case of an overload or a short circuit on one of the outputs, the control transistor of that channel (T1...T10) will be
damaged. Replace it by a transistor of the same type (BC640).
•
Velleman cannot be held responsible and all warranty becomes void in case of user modifications to the module.
•
A blown fuse always has to be replaced by a fuse of the same type (4A – FAST) to avoid fire hazard.
8