nedis HHGS300 Kurzanleitung Seite 5

a
Quick start guide
Handheld Garment Steamer
For more information see the extended manual online:
ned.is/hhgs300
Intended use
This product is intended to remove creases and wrinkles in various
types of fabric.
The product is intended for indoor use only.
Any modification of the product may have consequences for safety,
warranty and proper functioning.
This product can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the product in a safe
way and understand the hazards involved. Children shall not play
with the product. Cleaning and user maintenance shall not be done
by children without supervision.
The product is intended for use in household environments for
typical housekeeping functions that may also be used by non-expert
users for typical housekeeping functions, such as: shops, offices
other similar working environments, farm houses, by clients in
hotels, motels and other residential type environments and/or in
bed and breakfast type environments.
Main parts (image A)
Steam outlet
Steam button
Handle
Standby LED indicator
Steam selector button
Low steam LED indicator
High steam LED indicator
Safety instructions
Indication for a hot surface. Contact may cause
burns. Do not touch.
- WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep the
packaging and this document for future reference.
• Do not immerse the product in water or other liquids.
• Never use the product in wet or damp locations, such as
bathrooms.
• Always check that the voltage of the product corresponds to the
mains voltage.
• Only fill the water reservoir with clean tap water or distilled water.
• Do not use the product if a part is damaged or defective. Replace
a damaged or defective product immediately.
• The power cable cannot be replaced. If the cable is damaged the
product should be scrapped.
• Do not use the product with an empty water reservoir.
• Keep the product out of reach for children under 8 years of age
when the product is switched on or cooling down.
• Children should be supervised to ensure that they do not play
with the product.
• Do not open the water reservoir during use.
• Do not direct steam towards people or other living objects. The
ejected steam is hot.
• Keep the power cable away from the ejected steam and hot parts
of the product.
• Do not pull the power cable to move the product.
• Only use the product as described in this document.
HGGS300
Net brush
Hair brush
Water reservoir cover
Measuring cup
Water reservoir
Power cable
• Do not drop the product and avoid bumping.
• Do not leave the product unattended when switched on.
• Do not disconnect the product by pulling the cable. Always grasp
the connector and pull.
• Do not touch the steam outlet when using the product. The
steam outlet is hot.
• Do not use the product on metal surfaces. The hot steam may
cause discolouring.
• Do not allow children to clean the product without supervision.
• This product may only be serviced by a qualified technician for
maintenance to reduce the risk of electric shock.
• Do not open the product, there are no user serviceable parts
inside.
• Before cleaning and maintenance, switch off the product and
disconnect the power. Let the product cool down completely
before filling the water reservoir or removing the brushes.
Before first use
Remove all packaging material, protective stickers and covers from
the product.
Filling the water reservoir (image B)
1. Rotate the water reservoir A counter clockwise and remove from
the handle A.
2. Fill the measuring cup A with water.
3. Remove the water reservoir cover A.
4. Fill the water reservoir A with water.
5. Place back the water reservoir cover A.
6. Place the water reservoir A on the handle A.
7. Rotate the water reservoir A clockwise to fasten the water
reservoir A to the handle A.
Attaching the brushes (image C)
Connecting the product
1. Place the product upright on a flat and stable surface.
2. Plug the power cable A into a power outlet.
The standby LED indicator A lights up to indicate the product is in
standby.
Switching on the product
Press the steam selector button A to cycle between the available
steam settings.
Choose between standby, low and high steam.
4
Wait until the low steam LED indicator A or high steam LED indicator
A lights up to indicate the product is heated up.
Using the product
1. Hang the wrinkled fabric in a vertical position.
Make sure the fabric hangs free so the steam does not gather on
the fabric.
2. Press and hold the steam button A to eject steam.
3. Slide the steam button A to the lock position to spray steam
continuously.
4. Move the product up and down to remove creases and wrinkles.
After use
1. Press the steam selector button A to switch the product to
standby.
The standby LED indicator A lights up to indicate the product is in
standby.
2. Allow the product to cool down.
3. Remove the brush A.
4. Remove the water reservoir cover A.
5. Empty the water reservoir A.
6. Place back the water reservoir cover A.
7. Place the product on the water reservoir A.
5