level one FCS-5042 Schnellinstallationsanleitung Seite 7

English
Using the Software CD to configure the camera

Power on your PC and insert the CD-ROM.

The setup page should load automatically. If it does not, please
select your CD-ROM drive manually to open the setup page.
 Select "Install Software" → "CamFinder". (Figure 1-1 ~ 1-2)

Click "Next" to start the installation. (Figure 1-3 ~ 1-5)

Click on "Finish" to complete the software installation. (Figure
1-6)

Run "CamFinder". (Figure 1-7 ~ 1-9)

The CamFinder will show MAC address and an IP Address of
available LevelOne Network Cameras. Highlight the MAC
address and double click to link to the selected device. (Figure
1-10)

Enter "root" for the name, and leave the password blank.
(Figure 2-1)

The following screen would appear automatically. Click
"Install" and proceed. (Figure 2-2)

Congratulations, you can use the camera through the network
to view the video.(Figure 2-3)
Installing IP CamSecure
Click "IP CamSecure" and follow the onscreen instruction or refer to
the user's manual to complete installation. (Figure 3-1)
Page 6