Traxxas 7424 Montageanleitung

Receiver Box Installation Instructions
2.5x12 CS
7425
3x12 BCS
7425
3x6 BCS
Traxxas, 1100 Klein Road, Plano, TX 75074, Phone: 972-265-8000, Fax: 972-265-8011, e-mail: support@Traxxas.com
Receiver Installation
3236
1. Install the receiver into the box. Make sure the box light pipe is
aligned with the receiver LED.
2. Install the servo wires and antenna through the cover and
plug the wires into the receiver.
3. Make sure the O-ring is properly seated into the groove in the
receiver box so that the cover will not pinch it or damage it in
any way.
7424
2578
4. Install the cover and tighten the two 3x12mm button-head
cap screws securely.
5. Inspect the cover to make sure that the O-ring seal is not
visible.
6. Arrange the wires neatly using the wire guides in the receiver
box.
7. Apply a small bead of silicone grease (Traxxas part #1647) to
the wire clamp.
2534
8. Install the wire clamp and tighten the two 2.8x12mm cap
screws securely.
TR A XXA S .com
Covers Parts #7424, 7425
KC1539-R00 Rev 121112