ensto PXA53.2 Bedienungsanleitung Seite 13

8. TEKNISK INFORMATION
• Monteringshöjd minst 1,7m.
• Innehåller en passiv infraröd detektorenhet (PIR).
• Märkspänning 230 V, 50 / 60 Hz.
• Detektionsvinkel: i horisontalt plan 360° och i vertikalt plan 135°.
• Ljuset släcks ca. 1 min...30min efter den sista rörelseobservationen (TIME - inställning).
• Känsligheten (funtionsområdet) SENS, luxnivån LUX (1 lx... oändlig) och den påkopplade tidens
reglering TIME.
...6D, .../...4E och.../...7E: LUX - läge max (= oändlig).
•
• ...4E: elektroniskt förkopplingsdon, tändtid 1...2 s.
• ...6D: dimmbart elektroniskt förkopplingsdon: ljusnivå 1 - 10% kontinuerligt påslagen, då PIR detektorn
reagerar ändras ljusnivån till 100%.
• Max yttre belastning: 400VA armatur belastning.
• Funktionslägen: automatfunktion i skymning, testläge och lux -reglering.
Teknisk hjälp: +46 8 556 309 00
1. INTRODUCTION
ENG
The light fitting is designed for ceiling mounting. It can also be mounted on a wall at a height of at least 1.7
m. The light will switch on automatically when a heat-emitting object such as a person comes into its sensor's
detection area. When choosing the place of installation avoid all interfering sources within the detection
area that might affect the light fitting's operation, such as ventilating grates, warm air fans, reflective glass
or wall surfaces, or other light fittings that are too close to the PIR (Passive Infra Red) sensor. Sunlight may
also trigger the device if it appears suddenly within the sensor's detection area during cloudy weather.
THE LIGHT FITTING SHOULD ONLY BE INSTALLED BY A PERSON WITH THE REQUISITE KNOWLEDGE
AND SKILLS.
USE ONLY THE BULB TYPE AND WATTAGE INDICATED ON THE LIGHT FITTING. THE PIR SENSOR CANNOT
CONTROL AN EXTERNAL LOAD EXCEEDING THE PERMITTED LEVEL!
TURN OFF THE POWER BEFORE MOUNTING OR REPAIRING THE UNIT.
KEEP THESE INSTALLATION INSTRUCTIONS FOR USE WHEN MOUNTING OR SERVICING THE UNIT AT
A FUTURE DATE.
Maximum external load: 400VA light fitting load.
On the AVD/AVR...6D types a minimal illumination level (1 - 10%) has already been set. This means that
the light glows dimly when the PIR sensor is not activated. The light intensity increases to 100% when the
PIR sensor responds to an object.
2. CONNECTION, see pic. 1
Connect the live wire to terminal L, the neutral wire to terminal N and the protection wire (yellow/ green striped)
to terminal . Connect the external load between connections
The light fitting's PIR sensor can be by-passed with a switch. This also enables the light fitting to be switched on
continuously. Connect the switch between terminals L and
parallel.
, and N, (see pic. 1 a).
(see pic. 1 b). Light fittings can be connected in
13