Safety Instructions; Configuration - Rebel Rb-0702 Bedienungsanleitung

SAFETY INSTRUCTIONS

Before use, read the contents of the manual carefully and
keep it for future reference.
1. Protect the product from moisture, water and other
liquids. Do not use or store the device at excessively
high temperatures. Protect the product from direct
sunlight and heat sources.
2. Keep the device out of the reach of children.
3. The device is intended for indoor use only.
4. It is forbidden to repair the equipment on your own. In
case of damage, contact an authorized service center
for inspection/repair.
5. ALWAYS disconnect the device from the power source
before cleaning.
6. Clean the device only with a soft, slightly damp cloth. Do
not use chemicals or detergents to clean this device.
LEDs
Diode Status
Lights up
4G
Flashes
4G
Lights up
Lights up
4G
Flashes
8
Meaning
The device is
connected to the
power supply
Wi-Fi works, no
connected devices
Wi-Fi works, one or
more devices are
connected to the
network
Connection to the
device via Ethernet
Data transmission
EN
Lights up green
Lights up blue
Glows yellow
4G
Lights up red
Flashing red

CONFIGURATION

Before starting the device, remove the antenna jack cover
and screw the antennas to the jacks.
SIM card installation
Slide the SIM card into the SIM slot on the bottom of the
device. Note the pictogram next to the slot, which
indicates the correct orientation of the SIM card
indentation.
Note: use microSIM cards only.
Connecting
Wired:
• Connect the Ethernet cable to the socket and to the
socket on the computer.
Wireless:
• Connect to the router's WiFi network. SSID of the
router: „RB0702_[ssid]".
Network configuration
• If the SIM card is not PIN-locked, just connect the router
to power. After a while, the connection will be
4G connection
HSPA+ connection
GSM/EDGE connection
No SIM card
Network searching /
PIN code lock
EN
9