Whirlpool ADN 201/1 Betriebsanleitung Seite 7

1 ― On / off switch for interior light. On / off switch for interior light I -(ON) O –
(OFF)
2 ― Thermostat knob. The thermostat is off when there is a zero (0) in the
thermostat indicator space. Turning the thermostat knob clockwise the
temperature in the compartment lowers.
4 ― Electricity supply indicator. When the appliance is connected to the electricity
supply, the green indicator light is illuminated.
INSTALLATION AND OPERATING CONDITIONS OF THE
Preparing the appliance for operation
It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
•
Therefore take out adhesive tapes from sides and simply lift the appliance up and
•
take out the board. Strip adhesive tapes off and open the door. Remove the spacer
above the door.
When positioning the appliance in chosen location, it will move more easily into
•
position if you lift the front a little and incline it backward allowing it to roll on its
casters. If your appliance is fit with screwed handles. Do not rise or push it
taking by handles.
Take two supports from the bag and insert them into the guides at the top back part
•
of the appliance (see fig. 2, page 1).
If the appliance is brought in from the cold (temperature is not higher
than +12 °C), you should wait for two hours before connecting it to
the mains.
The appliance should not be connected to the mains until all packing
and transport materials aren't removed. Suitably dispose the packaging
material.
Positioning
Place the appliance in a dry, well ventilated room.
•
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
Do not cover the ventilation holes at the top of the appliances – it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between
the top of the appliance body and any furniture that may be above it. If this
requirement is not followed, the appliance consumes more electrical energy and its
compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm must be left between the
•
appliance body and the wall (see fig. 3, page 1).
APPLIANCE
6