Before Use - aidapt Prasident Gebrauchs- Und Wartungsanleitung

INTRODUCTION
Thank you for deciding to purchase from the Aidapt President Grab Rail/Grab Bar range. This
range is manufactured from the finest materials and components available. When installed
and used correctly they are designed to give many years of reliable trouble-free service.
Please examine your product for any visible damage before using. If you see any damage or
suspect a fault, please contact your supplier.
NB. This equipment must be installed by a competent person.
VY445/VY446/VY447
VY448/VY449/VY450
VY451/VY452/VY453
VY432/VY433
VY425/VY426/VY427
VY425B/VY426B/VY427B President Ribbed Grab Bar (35 mm)
N.B. Any weight limits quoted are based on the product performance with
secure fixings.

BEFORE USE

Carefully remove all packaging. Avoid using any knives or other sharp instruments
•
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
•
do not use your product as it may compromise your safety, but contact your
supplier for support.
FIXING GRAB BARS/GRAB RAILS
Firstly check the substrate where you intend to fix your Grab Rails/Grab Bars, ensuring that it
is sound. Also check the type of substrate you intend to fix to, e.g. brick/ block timber or
concrete.
Never drill through pre-stressed concrete to install a President product.
Always check the type of fixing you are going to use on this substrate for their compatibility.
We suggest that for sound brick and block that a minimum screw length of
50 mm x size 10 is used with a suitable rawl plug and screws, in accordance
with the guidelines issued by the fixings manufacturer.
It is recommended that stainless steel screws are used so as to avoid the
chance of rusting.
Fixing and Maintenance Instructions
President White Grab Bar
President Blue Grab Bar
President Red Grab Bar
President White/Blue Grab Bar
President Ribbed Grab Bar (32 mm)
2
Ver.2 08/2012 (1575)