Imetec N9305 Bedienungsanleitung Seite 16

Air flow button (2C)
0 = OFF
1 = medium air flow
2 = strong air flow
EN
Cold air shot button (2A)
If the appliance is equipped with this button, it can be used to set the
styling.
• If this button is pressed while the appliance is on, the hot air cools
down and the set style lasts longer.
• Once the button is released, the appliance returns to a hot air flow
at the selected level.
o n .
MAINTENANCE AND CLEANING
Cleaning the appliance and accessories
Clean the appliance and the accessories (diffuser, nozzle) with a
damp cloth when needed. Do not use solvents or other aggressive
or abrasive detergents. Otherwise, the surface could be damaged.
Check the intake opening of the appliance regularly and remove all
hair and dust.
Cleaning the intake filter (1)
If the appliance is provided with an intake filter, clean it as follows:
• Open the filter cap (1B) as shown in the figure.
• Wipe the front and rear of the retina (1A) and the filter cap (1B) with
a damp cloth.
• Let the parts dry well and put them back on in inverse order.
NOTE: the more dust is present in the place where the
hair dryer is used, the more often the filter must be cleaned.
WARNING!
the appliance from the socket
before cleaning or performing
maintenance.
WARNING! Make sure all cleaned parts
are completely dry before reusing the
appliance.
STORAGE
WARNING! Risk of fire. Wait for the
appliance to cool completely before
storing it.
Temperature button (2B)
1 = low temperature
2 = medium temperature
3 = high temperature
Always
14
disconnect