Whale AK1005 Montage- Und Gebrauchsanweisungen Seite 2

6. PARTS
QTY: 1
7. INSTRUCTIONS FOR INSTALLATION
Wiring: See Figure 1A or Figure 1B. For AK1006 and Ak1007 see also Figure 1C.
Figure 1A Wiring Diagram - For Single Sensor Models
Figure 2A AK1005 / AK1006
Instructions for Use
Once installed, turn on shower or tap to fi ll grey waste tank. Ensure the pump is operating and waste water is being removed from the tank. Note: If using a seacock,
ensure it is open before use.
8. MAINTENANCE
For best performance, the sensor faces on the lid must be cleaned from debris/residue regularly, at least every 3 months. See Figure 3. Do not use an abrasive
cleaner.
The lid is not a serviceable part. The yellow cover must not be removed and doing so will invalidate warranty.
It is advisable to have an annual check on all plumbing and fi ttings to prevent leaks and blockages.
Grey Waste Lid with integrated sensor(s)
A
Figure 1C AK1006 / AK1007
Primary sensor wires -
Connect to Grey Waste Pump
connect to grey
Figure 3 Cleaning / Maintenance
Figure 1B Wiring Diagram - For Double Sensor Models
B
Position
A
B
C
C
Secondary sensor wires -
Connect to high level alarm or
connect to high level alarm
secondary Grey Waste Pump
or secondary grey waste pump
Wire
Positive from battery
Not Used
Positive to pump
Primary sensor wires -
Connect to Grey Waste Pump
connect to grey waste pump
Figure 2B AK1007 / AK1008