Werbung
Verfügbare Sprachen
Verfügbare Sprachen
www.witeg.de
5 Positioning the device and commissioning
1. Follow especially the safety instructions marked with following symbol:
2. Remove the package and perhaps soiling carefully.
3. If there are any unexpected transport damages, please inform your forwarder and your
customer service.
4. Attach the clamp to the tripod rod.
5. Stick the device at the clamp and tighten the screw.
6. Check that each connection fits close.
7. Fix the stirrer in the chuck with included chuck key.
8. connect the remote controller to the device
9. Before you connect the device with the electrical outlet, please let some time laps until
the device is acclimatised.
10. Make sure that you follow all safety instructions.
11. Connect the remote controller with the power outlet.
12. Switch the device on and start the process.
6 Job description
First switch the device on.
If there is a value stored the stirring process starts by pushing the Jog-Shuttle.
If there is no value stored the stirring process starts by turning the Jog-Shuttle.
Change the set speed during the stirring application by turning the Jog-Shuttle.
Start and stop by pushing the Jog-Shuttle.
If you work with the same speed often you can store this value and thereby you need not
to set often used speed values in every usage.
To store values you only have to hold the Jog-Shuttle knob pushed for two seconds until
the value in the first line in display is blinking.
Delete stored values by over-storing with "0".
7 Maintenance and cleaning
Please read the whole safety instructions before you start to maintain or clean the
device.
Pull the power plug out of the electrical outlet.
Only use care cleaning agents and soft cleaning rags.
Organic lotions, strong chemicals and rough cleaning rags can damage the device.
If you not want to use the device for a long time, pull of the power plug and keep it dry in
the package.
Only use original spare parts.
witeg Labortechnik GmbH, WiseStir
11
®
HS-T Overhead Stirrer
Werbung
