RUSTA BRUKSBO Gebrauchsanweisung Seite 6

USE
1. Attach the motor filter (B) to the fabric filter's motor filter holder (A).
NOTE!
Check that the motor filter (B) is correctly attached
around the motor filter holder (A). It should also be cleaned
after each intensive use.
2. Attach the internal ash filter (C) and make sure that the edge seals tightly around
the edge of the container.
3. Place the cover (F) on the container (L) and secure it with the clamps (K).
4. Attach the metal hose (D) to the suction connector (E) on the ash vacuum cleaner.
5. Connect the ash vacuum cleaner to the mains and switch it on.
6. You can now clean ash from your stove, fireplace or barbecue using the nozzle (M).
• If the nozzle becomes blocked by a piece of charcoal or similar, switch off the ash
vacuum cleaner. Carefully tap the nozzle against the inside of the stove or fireplace
to dislodge the object.
• If the suction power deteriorates during use, turn off the ash vacuum cleaner,
remove the clamps from the cover and shake the cover to clean the filter.
• Once you have finished cleaning, switch off the ash vacuum cleaner and hold
the nozzle and hose vertically to allow loose ash to drip down into the container.
• Once the container is full up to the suction connecter, empty the contents of
the container out into suitable packaging material and dispose of it.
• The ash vacuum cleaner can also blow if you attach the metal hose (D) to the exhaust
connecter (I). Be particularly careful when using this function! When blowing,
the container must be completely empty and clean, and the filter must be removed.
6