SAFETY RULES
RECOMMENDATIONS
CAUTION
GENERAL TERMS
OF WARRANTY
www.inventini.com
1. Inflatable pillar is not adapted to severe weather conditions such
as strong winds, heavy rains, storms or hailstorms.
2. In case of strong winds, disassemble the pillar.
3. You shouldn't leave your pillar unattended.
4. Keep the pillar away from sources of heat and open flames. Please
do not place any sources of heat direclty at the pillar beacuse the
materials can melt at high temperatures.
5. By special order, you can have your pillar made of flame retardant
fabric (which meets the standards of B1 requirements)..
1. Read these instructions carefully before you get to work.
2. Be cautious while setting up the pillar to avoid being hurt and prevent
other damage.
3. Before disassembling the structure, the pillar must be thoroughly
cleaned. Any spots or stains on the fabric should be removed
immediately with a warm damp cloth. Do not use detergents or
pressure washers. Follow the instructions on the label.
4. Storing a dirty or damp pillar can result in a breakdown of
the materials as fabrics tend to mold, mildew and/or rot. Before
putting your pillar in its transport bag for storage, make sure
it is clean and dry. Store it in a dry place to avoid moisture
contamination. In case of bad weather, repack your pillar to avoid
damage, but as soon as it's possible, unpack it once again to let it dry.
5. With recurring gusts of wind, check anchoring systematically.
6. Pillar may be used with wind up to 38 kph. During stronger wind, it
is recommended to disassembling the pillar.
7. Do not block the safety valves in any case. The safety valves are
located on the top of the pillar, under the fabric.
The air in the product changes it's volume under the influence
of temperature. High temperature increases the volume of air. The product
becomes more taut. Low temperature reduces the volume of air.
The product becomes less taut.
General terms of warranty can be downloaded from the
manufacturer's website.
EN
5