Herunterladen Diese Seite drucken

infra world INFRARED SURFACE HEATING Montageanleitung Seite 2

Werbung

D
Stromstärke
Bezeichnung
(inkl. Holzrahmen)
Seitenteil
300 x 820 x 50 mm
Seitenteil
450 x 820 x 50 mm
Rückenteil
650 x 820 x 50 mm
Rückenteil
850 x 820 x 50 mm
Fußteil
650 x 330 x 50 mm
Fußteil
850 x 330 x 50 mm
Fußteil
925 x 330 x 50 mm
Sehr geehrter Kunde,
Kontrollieren Sie anhand der Stückliste, bevor Sie mit der
Arbeit anfangen, ob alle Einzelteile auch tatsächlich mitge-
liefert wurden. Sollten Einzelteile ausnahmsweise fehlen,
benachrichtigen Sie Ihren Händler bis spätestens 14 Tage
nach Erhalt.
Heben Sie den Lieferschein, die Rechnung und die Montage-
anleitung für Rückfragen gut auf. Bei eventellen Rückfragen
wenden Sie sich an Ihren Fachhändler.
WARNHINWEISE:
• Abdecken der Heizkörper verursacht Brandgefahr!
• Infrarotkabinen bzw. Saunen nicht länger als ca. 30 bis 40
min benützen (je nach körperlicher Verfassung).
• Kranke Personen sollten vor der Benützung einen Arzt
befragen.
• Nicht von hilflosen und wärmeempfindlichen Personen
oder Kleinkindern benutzen.
• Vor dem Infrarotkabinen- oder Saunabesuch die Haut nicht
stark reiben oder hautdurchblutungsfördernde Mittel
einnehmen.
• Keine Substanzen einnehmen, die das natürliche Hitze-
schmerzempfinden unterdrücken (Alkohol, Medikamente,
Drogen).
• Bei zu hohem Hitzeempfinden auf der Haut die Sitzposition
ändern.
HINWEISE:
• Öffnen und Reparaturen dürfen nur von einem Fachmann
durchgeführt werden.
• Vor dem Öffnen der Steuerung oder vor einem Austausch
der Heizelemente immer den Netzstecker ziehen.
• Bei Fragen wenden Sie sich an Ihren Fachhändler oder an
unserer Vertriebspartner.
• Netzstecker muss nach dem Aufstellen leicht zugänglich
sein.
• Wenn die Anschlussleitung dieser Infrarotkabine beschädigt
wird, muss sie durch den Hersteller, seinem Kundendienst
oder von ähnlich qualifizierten Personen ersetzt werden,
um eine Gefährdung zu vermeiden.
Technische Änderungen vorbehalten
© by TPI GmbH, Frankenburg, Austria
230 Volt~
B x H x T
Leistung
130 W
230 W
350 W
460 W
125 W
170 W
180 W
GB
Voltage
Description
(incl. wooden frame)
Side part
300 x 820 x 50 mm
Side part
450 x 820 x 50 mm
Back part
650 x 820 x 50 mm
Back part
850 x 820 x 50 mm
Bottom part
650 x 330 x 50 mm
Bottom part
850 x 330 x 50 mm
Bottom part
925 x 330 x 50 mm
Dear customer,
Before starting to assemble the cabin, please check whether
all elements have actually been supplied. If, in the unlikely
event, any elements are missing, inform your dealer before
starting to assemble, up to 14 days after receipt.
Please keep the delivery note, the bill and the assembling
instructions carefully in case of later queries. In case of
eventual queries go to your specialised dealer.
WARNINGS:
• Covering the heater causes fire risk!
• Do not use infrared cabins or saunas for more than 30 or 40
min (depending on your physical condition).
• If in doubt, consult your doctor.
• Not for use of helpless and heat prone people or small
children.
• Before using the heat cabin or sauna, do not rub the skin
strongly nor use cures that stimulate the skin's blood
circulation.
• Do not take any substances that suppress the natural heat
pain threshold (alcohol, drugs, medication).
• In case of too strong heat feeling on the skin, change the
sitting position.
NOTES:
• Only experts are allowed to open and repair.
• Take the mains plug out of the socket before opening the
controls or exchange the heating elements.
• If you have any questions, turn to your specialised dealer or
our sales partners.
• The mains plug must be easily accessible after putting up
the heat cabin.
• If the connecting cable of this heat cabin is damaged, it
must be replaced by the manufacturer, the customer
service or similar qualified persons in order to avoid any
danger.
Subject to technical modifications
© by TPI GmbH, Frankenburg, Austria
230 Volt~
W x H x D
Power
130 W
230 W
350 W
460 W
125 W
170 W
180 W
2

Werbung

loading