FLINQ FQC8287 Bedienungsanleitung Seite 3

Manual
EN
Installing the sensor bin
1 Install batteries
Install 3x AA batteries into the
battery compartment according to
+/- instructions. Place the battery
compartment back and activate the on/
off switch.
3
Intelligent sensor
Place your hand gently over the sensing
area and the lid will open. After that, the
lid will close automatically after 15 sec.
2 Place garbage bag
Lift the black handles inside the bin
and put the garbage bag around these
handles. Place the lid back on the FlinQ
sensor bin.
4 Manual operation
Tap the button on the left side of the lid,
the bin will slowly open. The trash can
will remain open during that moment.
Press the button on the right side, the lid
will slowly close.
Troubleshooting
Trouble How to solve
Check wether batteries are installed properly according
Lid opens unusual
to "+" and "-" instruction. Or check whether lithium
battery incurs low power, and then re-open the power
source switch.
Check wether sensing area is clean or not, please use
neat cloth to wipe if it is dirty.
Check wether electric circuits are damp. If yes, please
Lid closes unusual
do not connect power source. You can only use the bin
if it is dry.
Check wether there is any obstacles around the lid. If
yes, please remove it.
Dry battery may incur low power, please replace it.
Dry battery may incur low power, please replace it.
Lid opens slowly
FlinQ Sensor Bin Swing 60L