Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Notes:
• Dual-output video is supported under MST in the following manner: MDP and
VGA, or MDP and HDMI.
• VGA and HDMI will not work simultaneously.
• The MDP port can be converted to an HDMI port with the use of a passive
MDP to HDMI cable.
• If your Mac does not support MST mode, only the mDP monitor will be
detected and dual mode will not work.
• When two monitors are connected simultaneously, the mDP will allocate the
necessary bandwidth first. The remaining bandwidth (up to 10.8G) will be
allocated to the second connected monitor.
• If two displays are connected simultaneously and the resolution of one display
is higher than the other, the second monitor may not function due to a lack
of bandwidth between the two ports. It is recommended to use the same
resolution for both displays to prevent this from happening.
• When connected to power through USB-C charging port, 15W is dedicated to
docking station and connected USB peripherals. Remaining power is used to
charge connected USB-C device.
• See Optional Accessories section for suggested cables.
• When the unit is connected to the USB-C port on your computer and to a
network via Cat5e/6 cabling, a network connection will be automatically
established. If no connection is made, you can manually establish one by going
to your computer's network settings page. For example, on a Mac you would
navigate to the Network section found in System Preferences, click the 'Assist
Me' button to get to the Network Setup Assistant, then follow the prompts to
establish a connection.
1. Connect USB-C port to USB-C port on your laptop, tablet or other
device.
2. Connect VGA port to VGA port on your monitor using a VGA cable.
3. Connect HDMI port to HDMI port on your monitor using an HDMI cable.
4. Connect mDP port to mDP port on your monitor using an mDP cable.
5. Connect USB-A hub ports to USB peripherals.
6. Connect RJ45 port to Ethernet network using UTP cable.
5
Werbung
