emil lux Caldirola Bedienungsanleitung Seite 9

Safety instructions
• The light may be installed indoors only.
• To operate this product safely, the user must have
read and understood these instructions for use
before using the product for the first time.
• Always keep the operating instructions within
reach.
• If you sell or pass on the device, you must also
pass on these operating instructions.
• When working on walls, ceiling or floors, pay
attention to any installed cables as well as gas
and water lines.
• Installation may be carried out only by a suitably
qualified electrical specialist.
• Use only connection clips authorised by the man-
ufacturer.
• Only use connection cables permitted by the
manufacturer.
• The light source of this luminaire is not replacea-
ble; when the light source reaches its end of life
the whole luminaire shall be replaced.
• This product contains a light source of energy
efficiency class <F>.
Risk of damage to the eyes! Never look di-
rectly into the LED.
Light source non-replaceable
Control gear non-replaceable
23 0V
23 0V
Installation
Note: The actual appearance of your prod-
uct may differ from the illustrations.
DANGER! Risk of fatal injury due to elec-
tric shock! Installation may be carried out
only by a suitably qualified electrical special-
ist.
Before installation, it must be ensured that
there is no current to the electrical network
(switch off at main switch or remove fuse).
Fault/malfunction
The lamp does not light up
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
► Assembly – p. 2
LED ceiling light
– Remove the holder.
– Drill the holes and insert dowels.
– Screw the holder firmly to the wall or ceiling.
– Connect the mains cable.
– Place the lamp in the holder.
Cleaning
– Wipe down the device with a dry or damp cloth.
Storage and transport
Storing
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
Transport
– Use the original packaging to ship whenever pos-
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No mains voltage?
Light source defective?
Luminaire switched on via switch?
Switch defective?
Connection cable defective?
Incorrect connection?
NOTICE! Risk of damage to the device!
Do not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
sible.
DANGER! Danger to life and limb!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
DANGER! Risk of fatal injury due to elec-
tric shock! All work to eliminate possible
faults should be carried out with the fuse
switched off. All work should be carried out
by a qualified electrician.
Remedy
Check fuse. Contact a specialist.
Check illuminant, replace if neces-
sary if possible
Check switch position
Contact a specialist.
Contact a specialist.
Switch off the fuse and check the
connection according to the wiring
diagram. Contact a specialist.
GB
9