La Hacienda Murcia Chimenea Large Benutzeranleitung Seite 9

Assembly Instructions
IMPORTANT! - Remove any packaging before use, but retain the safety instructions and store them with this product.
STEP 1 - Attach the 3 legs (14) to the bottom bowl (13), using 2 sets of bolts, washers and nuts (A) per leg.
STEP 2 - Attach the top bowl (6) to bottom bowl (13) using bowl/grill brackets (10 &11). Use 2 sets of bolts, washers
and nuts (C) per bracket. Make sure the brackets are positioned correctly as these are also used to support
the grill. The longest edge of the side brackets (10) need to face towards the front of the chimenea.
STEP 3 - Attach bottom flue section (5) to top bowl (6) using 3 sets of bolts, washers and nuts (C).
STEP 4 - Attach top flue section (3) to bottom flue section (5), using 3 sets of bolts, washers and nuts (B).
STEP 5 - Attach door latch (8) to left side of top bowl opening using pre-attached nut and bolt.
STEP 6 - Attach carry handles (7) to the side of top bowl (6) using pre-attached bolts. Add washers and tighten nuts
on the inside.
STEP 7 - Attach the mesh safety door (9) to right side of top bowl (6) using pre-attached bolts and nuts. Attach the
door latch (16) to the door (9) using pre-attached bolts and nuts.
Note: A little pressure on the door handle may be needed to locate this within the door latch. This secure
fitting is to ensure the door can not accidentally be opened during use.
STEP 8 - Place fuel grate (11) into base of chimenea.
STEP 9 - To use slide in grill (4), first attach grill handles to the grill by locating the handle ends onto the bars at
the front of the grill. We recommend squeezing the handles first to ensure a good fit. The grill can now slide
onto the chimenea on the left and right brackets (10) and slot over the rear bracket (11) to secure it.
The product is now ready to use but please ensure you have read these instructions thoroughly prior to use.