Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Installation
1. Before installation, turn off the main power supply and ensure that the lamp is not charged.
Attach the ground spike to the light by rotating it in a anti-clockwise direction.
2. Position and insert the light into the ground.
3. Position your light in the required direction. Move the head up and down by loosening the
screw bolt holding the light in place.
4. Once positioned tighten the screw bolt. Repeat this step for all lights you wish to set up.
4
Download App
Scan the QR code as below, get and install essentials Smart Home App for IOS and Android system.
5
Configuration
1. Start the essentials Smart Home App and create a new account or log into your existing account.
2. Click on the „+" in the top-right of the screen to add your new device.
3. Select the applicable product type from the list of product.
4. Ensure the led bulbs are quick flashing (flashing 1 times per 0.5 second). If the led bulbs aren't
flashing: Insert the plug 3 times into the socket or pull it out again pull it out of the socket 3
times until the LED lamp starts to flash.
5. You are advised to enable Bluetooth.
6. Confirm the Wi-Fi network and password.
Note: only 2.4GHz Wifi is supported.
7. Once the spots are found by the app, you can add and name each spot individually.
Note: the device name will be used by Amazon Alexa and Google Assistant too.
Note:
1. If the device is not connected to the app, it will flash for 3 minutes and go off. 2.
2. If the device is accidentally reset, the device will reconnect after 3 minutes of flashing or you
can unplug it briefly and plug it back in. The device will then be reconnected.
2
Werbung
