WorkPro W099030AU Benutzerhandbuch Seite 5

OPERATION INSTRUCTIONS
Insert a glue stick with diameter 7mm into the melting chamber through the
back of the glue gun and push it forward until it goes no further
Plug in the glue gun and pre-heat for 3-5 minutes
Once it is up to melting temperature, pull the trigger and squeeze the glue
comes out. Repeat this step as needed.
Insert an additional glue stick into the back as needed
APPLICATION
Adhere or joint two work pieces when you repair furniture, fix electrical wire,
install floors, fix toy and model, etc.
Repair a leak or crack as waterproof material in the bucket, rain gutter, etc.
Seal cartons or other package
Applicable for different surfaces, such as wood, plastic, foam, fabrics,
paper, cardboard, ceramics, etc.
5