Topens TC148 Bedienungsanleitung

User Manual of Wired Push Button
(Item No. TC148)
Installation of the Waterproof Push Button
Step 1: Separate the back cover from the push button and drill four holes in the wall
corresponding to the 4 installing holes on the back cover of the push button.
Step 2: Insert plastic anchors into the 4 holes drilled in the wall and then install the back
NOTE: Please read this manual carefully before installation.
cover to the wall with the screws. (The plastic anchors and the installing screws are not
included in the kit).
Step 3: Wire the push button to your opener and then route the wire through the bottom of
the push button. Finally fix the front cover of the push button to the back cover with the
Feedback & Review
screws included in the kit.
Your comments and suggestions are important to us
as they help us provide the best possible service.
Should you have any need to contact us, the info below will help you get in touch:
TOPENS Website
www.topens.com
Connection of the push button
Contact Us:
You can connect the COM and L1 terminals of the push button to the terminals for push button of
the gate opener. No matter the polarity.
E-mail: support@topens.com
Kindly include your Product Model, Purchasing Date & Site, Order #,
and your contact information. All your concerns will be replied within 24 hours.
Tel: +1 (888) 750 9899 (Toll Free USA & Canada)
C030640 VER 22a