Peavey PV i 6500 Bedienungsanleitung Seite 18

Effects Section
MaStEr MutE LED
18
When the LED is ON it indicates the master
mute is activated.
MaStEr MutE
19
Depressing this button mutes channels one
through five, preventing signal from passing
to the power amplifier. This button does not
affect channel 6.
NOtE: On the PVi 6500 the Master Mute
switch will send a Play/Pause signal to the
iPod ® dock when MutED; when uNMutED
the Master Mute switch sends a StOP
signal to the iPod dock. this function is
extremely useful for playing program music
during breaks. a StOP command differs
from a PauSE command in that it will begin
at the next song in the play list the next
time the iPod receives a PLaY command.
KOSMOS
20
The Kosmos -C module uses special circuitry
21
to enrich the sound of your system. The
LOW control is not just a simple bass boost.
It provides 'natural bass enhancement' by
adding harmonically related bass signals
that track envelope of the original signal.
The Kosmos-C HIGH control can be used to
add clarity to dull signals.
EFFECtS tYPE taBLE
22
This table lists the types of effects available
and the abbreviation used for each effect in
the first character of the LED display. The
chart also lists the parameter associated
with each effect, which is controlled by turn-
ing encoder 24. A more detailed list of ef-
fects can be found at the end of this manual.
EFX LED
23
This LED indicates the type of effect currently selected. When turning encoder 27 the display will flash
until the encoder is depressed, selecting a new effect.
ParaMEtEr CONtrOL
24
This encoder controls the parameter associated with the selected effect, listed both on the mixer (22) and
in this manual. The parameter control is used to make adjustments to the sound of the effect.
EFX MutE
25
When pushed this button bypasses the effects section, letting the user listen to the dry signal. When
depressed and muted, LED 23 displays two dashes "--".
CLIP LED
26
This LED blinks RED when the signal to the effects section is too hot and is causing distortion. Find the
source of the hot signal by reducing the EFX SEND (4) on each channel until the LED is no longer clipping
(blinking red).
EFFECtS SELECt
27
Turn and push this encoder to select the desired effect.
® -C
18 19
22
18
20 21
23 24
25 26 27