Werbung
Kuma
User manual
Thank you for purchasing the Lightpro Kuma.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Kuma is an LED wall lamp for outdoor use.
The fixture can be mounted on a solid surface or placed
in the ground with the supplied spikes. This product may
only be used as outdoor lighting in combination with
the Lightpro 12-volt system. Any alterations made to the
product may have consequences for the safety, guarantee
and correct functioning of the product and/or other parts
of the system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
[Figure A]
1. Fixture Kuma
2. Screws
3. Plugs
4. Lightpro connector
5. Hex key
Lightpro Kuma
184W
LED 6W AC/DC 12V
6W
300 lm
3.000K
25.000
35 x145 mm
IP44
-20 °C to 50 °C
3m
No
Not replaceable
10.000
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
INSTALLATION
[Figure B]
1. Remove the screws from the fixture with the included
key (Figure A [5]).
2. Remove the hood from the fixture.
[Figure C]
Optional: Putting the cable through the wall.
1. Drill a hole (Ø10 mm) in the wall for the cable.
2. Open the screw connector in the cable.
3. Put the cable through the hole in the wall.
4. Connect the screw connector in the cable.
[Figure D]
1. Install the back plate with the included screws.
If necessary, drill holes in the wall and use the included
plugs.
[Figure E]
2. Place the hood over the back plate.
3. Place the screws in the fixture.
4. Fix the hood by fastening the screws with the included
key (Figure A [5]).
Werbung
