Maintenance And Service; Working Advice; Laser Viewing Glasses (Accessory) - Defort DLL-10T-K Bedienungsanleitung

Switching On and Off
To switch on the measuring tool, push the On/Off switch
3 to the "On" position.
● Do not point the laser beam at persons or animals
and do not look into the laser beam yourself, not
even from a large distance. To switch off the meas-
uring tool, push the On/Off switch 3 to the "Off" posi-
tion.
● Do not leave the switched on measuring tool unat-
tended and switch the measuring tool off after use.
Other persons could be blinded by the laser beam.
WORKING WITH AUTOMATIC LEVELLING
Position the measuring tool on a level and fi rm support
or attach it to a tripod 6.
After switching on, the levelling function automatically
compensates irregularities within the self-levelling
range of ±4°. The levelling is fi nished as soon as the
laser beams do not move any more.
When not within the self-levelling range of ±4°, work-
ing with the measuring tool is not possible, because it
cannot be assured that the laser beams run at a right
angle to each other.
In case of ground vibrations or position changes during
operation, the measuring tool is automatically levelled
in again. To avoid errors, check the position of the hori-
zontal and vertical laser line with regard to the refer-
ence points upon re-levelling.

WORKING ADVICE

A tripod 6 offers a stable, height-adjustable measuring
support. Place the measuring tool via the tripod mount
8 onto the 1/4" male thread of the tripod and screw the
locking screw of the tripod tight.

LASER VIEWING GLASSES (ACCESSORY)

The laser viewing glasses fi lter out the ambient light.
This makes the red light of the laser appear brighter
for the eyes.
● Do not use the laser viewing glasses as safety gog-
gles. The laser viewing glasses are used for im-
proved visualisation of the laser beam, but they do
not protect against laser radiation.
● Do not use the laser viewing glasses as sun glasses
or in traffi c. The laser viewing glasses do not afford
complete UV protection and reduce colour percep-
tion.

MAINTENANCE AND SERVICE

Maintenance and Cleaning
Store and transport the measuring tool only in the sup-
plied protective case.
Keep the measuring tool clean at all times.
Do not immerse the measuring tool into water or other
fl uids.
Wipe off debris using a moist and soft cloth. Do not use
any cleaning agents or solvents.
Regularly clean the surfaces at the exit opening of the
laser in particular, and pay attention to any fl uff of fi -
bres.
Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
your unwanted machines to your local SBM Group
dealer. Here they will be disposed of in an environmen-
tally safe way.
GB
7