Leica Laser TV Screen Kurzanleitung Seite 27

▸ Carefully place the assembled inner frame on the screen. Align the corners of the screen with the corners of the assembled inner frame, as shown in the fig­
ure below. To prevent the screen from being pierced, the angled edge of the frame must not come into direct contact with the screen.
▸ Use the spring hook ( ) to attach the inner frame's springs into the holes on the outer edge of the screen. Each hole on the outer edge of the screen goes
K
with one spring.
▸ Start by securing the four corners. Two people should use the spring hook (
this in the following order: first 1–1 → 2–2 → 3–3 → 4–4 and then 5–5 → 6–6 → 7–7 → 8–8.
• Note: there is one additional spring on each side that can be used if necessary.
Top
Bottom
) to attach the springs into the holes on the outer edge of the screen. Please do
K