Werbung
EN
Meaning of symbols
Caution
Cross reference to other products
or documentation
Cross reference to another page in
this document
Correct installation
Incorrect installation
Optional
Large and small format tiling work
Installation tip
i
4
Important information -
please note
Area of application
The BetteLevel Set B57-0421 is used for the installation
of Bette shower trays and shower surfaces with a side
measurement up to and including 120 cm.
The BetteLevel Set B57-0422 is used for the installation
of Bette shower trays and shower surfaces with a side
measurement over 120cm.
Both sets cannot be combined with BetteAir shower tiles or
BetteDelta and BetteQinta shower trays.
Safety information
– The safety, function and integrity of the product can only be
guaranteed if the information provided here is observed.
Failure to do so may result in injury or damage to persons
or property. The manufacturer is not liable for any damage
resulting from a failure to observe the instructions.
– It is essential that you follow the instructions given in the
installation guide in order to prevent installation errors and
damage to the product.
– Please observe the general safety and accident prevention
regulations in addition to the information provided in these
instructions.
About this guide
– This installation guide must be available for the entire
duration of the installation process. If the installation is to be
carried out by several individuals (e.g. fitter, tiler etc.), then the
installation guide must be passed on as appropriate.
– The dimensions are given in mm (millimetres).
– The illustrations are not true to scale.
– Subject to technical changes.
Installation information
– Only to be installed by qualified specialists.
– Handle the product with the greatest care in order to prevent
damage. Rings and other items that could damage the
product must be removed before installation.
– Large, bulky or heavy items must be installed by two people.
– Large and small format tiling work should be performed
pursuant to DIN 18157.
– For the height of the feet, the distance from the unfinished
floor to the upper edge of the finished floor (abbreviation
„OKFF", is determined by the metre plan available on site)
must be determined. → Thickness insulation + screed +
bonded waterproofing + tile adhesive + floor tile
Please also observe the separate documentation
(e.g. for waste fittings).
Werbung
