Kress 500 TBS Bedienungsanleitung Seite 6

English
6
1 Illustration
1 Depth gauge
2 Bit holder
3 Adjustment ring for depth stop
4 ON-/OFF-switch with electronics
5 Latch, mains cable module
6 Mains cable module
7 Holding button for continuous operation
8 Rotational direction switch
9 Belt hook
Accessories illustrated or described are not always included as
standard delivery items.
2 Application
The dry wall screwdriver is universally usable for
screw driving in dry construction (drywall, plaster-
board) as well as pressboard or fibreboard on wood or
metal with quick dry wall screws or for the setting of
sheet metal and wood screws in interior construction.
Safety Instructions and
3
Accident Prevention
Before operating the machine, please read through
the operating instructions completely, follow the
Safety Instructions in this manual as well as the gen-
eral Safety Instructions for Power Tools in the
accompanying booklet.
Caution!
– Outside power sockets must be protected with
residual-current-operated circuit-breakers (r.c.c.b.).
– Do not drill holes into the housing to label the
machine. The protective insulation will be bridged.
Please use self-adhesive labels.
– Always lead cables away towards the back of the
machine.
Double Insulation
Our equipment is designed in accordance with Euro-
pean regulations (EN standards) for the utmost safety
of the user. Machines with double insulation always
carry the international
not require earthing. A two-core cable is sufficient.
The machines are interference-suppressed in accord-
ance with EN 55014.
symbol. The machines do
4 Technical Data
Dry Wall
Screwdriver
Input
Output
No-load speed
Adjustment range
Tool holder
Max. screwing into
wood
Screw length
Torque at rated load 1.21 Nm
Clamping collar dia. 43 mm
Measurement
accross the corner
Weight
5 Putting into Operation
Before the first operation check that the mains voltage
corresponds to that given on the machine nameplate.
Trigger switch with button for continuous
operation
The machine is set in operation by pressing in the
handle switch (4). The holding button (7) on the side
of the switch can be pressed for continuous operation.
To release the continuous operation merely depress
the switch, which makes the holding button spring
back automatically.
The bit rotates only after the screw is in contact and
pressure is applied to the machine.
Electronic speed control
This machine is fitted with a full-wave switch. The
speed can be controlled infinitely variably in the range
0–3 000 r.p.m. / 0– 4 650 r.p.m. and adapted for
processing various materials and applications.
Important!
Continuous operation under strong load and low
speed can overheat the motor.
Allow the motor to cool down in no-load when set at a
high speed!
Rotation direction selector
Pressing the rotation direction selector as far as it will
go causes the drill to rotate in the corresponding direc-
tion.
Attention! Change direction of rotation only
when the motor has ceased turning!
500/505 TBS
500 TBS 505 TBS
500 W 500 W
255 W 255 W
3 000 r.p.m. 4 650 r.p.m.
0 – 3 000 r.p.m. 0 – 4 650 r.p.m.
1/4" 1/4"
6 mm 5 mm
60 mm 60 mm
0.77 Nm
43 mm
22.5 mm 22.5 mm
1.5 kg 1.5 kg