fontastic Planet Bedienungsanleitung Seite 6

GB
Suitable plugs
Devices with the following plug types are suitable for
operation with the Planet adapter:
Suitable sockets
The adapter can be operated with mains sockets of
the following types:
Type B: America, Canada, Cuba, Costa Rica, etc.
Type G: England, Hong Kong, Singapore, etc.
Type I: Australia, China, Argentina, Uruguay, etc.
USB ports
The Planet adapter is equipped
with 2 USB-A ports. These
allow simultaneous charging
of USB-enabled devices.
Connect your devices to the
USB ports of the Planet adapter
using a USB charging cable.
LED Indicator
Lights up continuously:
- Normal operation
9
Not lit:
- Possible overload, remove a plugged device and
check the LED again.
- Defective fuse, please check the fuse of the
Planet adapter.
Replace fuse
The Planet is equipped with an internal 10A fuse
(equivalent to 1000W at 100V and 2500W at 250V).
If overloaded, the fuse will blow and the current
flow will be interrupted. Open the fuse compartment
marked „fuse" with a hard object, then remove the
fuse as shown (Fig.1). Insert a new fuse into the fuse
compartment, and then insert the fuse compartment
into the unit (Fig.2).
Fuse specification:
250V AC, max 10A, 6.3 x 25.4mm.
Fig. 1 Fig. 2
Safety instructions:
• Mains sockets for operation with the Planet
adapter must be freely accessible.
• Never open the device.
• Do not immerse the device in water and protect
it from moisture.
GB
10