Sibo FLUIDRA RK445 Bedienungsanleitung Seite 2

Connecting the E-Swim to the Sugar Valley in
combination with a Communication Set (Article
Setting up the E-Swim at control over the Sugar Valley?
Press "Enter" : the Menu opens.
Go to "External Control" and press "Enter".
Go to "Settings" and press "Enter".
The following settings must be set as
follows:
5. Config:
6. Source Speed:
7. Start Input:
8. Speeds Mode:
Press "Enter" to select these settings.
With the "Check Mark"
confirmed.
With the "Cross" , your selection is
cancelled, and you go back.
RK445).
Go back to the Menu again.
Go to "External Speeds" and press "Enter".
At "Control Mode", fill in "Flow" or "Speed",
depending on what you want to use.
Now X1, X2, and X4 can be adjusted as
Enable;
desired.
Digital;
Speeds;
Priority.
, the selection is
Press the "AUTO" button after the setup.
The light on the left, next to the buttons,
lights up.
If this light is on, the E-Swim is controlled by
the Sugar Valley.
- Select with "Enter"
- Confirm with "Check Mark"
- Cancel with "Cross"
.
.
.