Chilitec 23744 Bedienungsanleitung Seite 2

ChiliTec GmbH, Bäckerberg 12, 38165 Lehre-Essenrode
Art.Nr. 23744
HOW DOES THE DOORBELL WORK WITH SENSORS AND KEY REMOTE CONTROL?
You can match RSL doorbell series PIR sensor and gate sensor with the doorbell together for use, or just match one of them. If you need to take doorbell(receiver)
as alarm( to choose alarm ringtone), and you must match the remote control, the remote control can activate and deactivate the sensor during use according to
the demand.
When you purchase the sensor and remote control, please pay attention that only special sensor and remote control can work with doorbell.
Remote Control Door Sensor PIR Sensor
STEP 1: PAIRING BETWEEN DOORBELL RECEIVER AND SENSOR/ REMOTE CONTROL
To pair sensor and remote control respectively with the doorbell receiver according to their manual, usually just short press the learning button of sensor or ON
button of remote control when the doorbell receiver enters into pairing code state.
STEP 2: ACTIVATE/DEACTIVATE THE SENSOR
1. Activate the sensor: Press the ON button of the remote control to activate the sensor, the receiver will make 1 beep, indicating that the sensor has been
activated.
2. Deactivate the sensor: Press the OFF button of the remote control to stop the sensor, the receiver will make 2 beeps, indicating that the sensor has been
cancelled.
When the sensor is triggered and the doorbell receiver will make the alarm sound for 2 minutes, you can press ON button of the key remote control to stop it
immediately, if you press OFF button to stop it, then the sensor function will be deactivated.
STEP 3: UNPAIRING BETWEEN DOORBELL RECEIVER AND SENSOR/ REMOTE CONTROL
To unpair sensor and remote control respectively with the doorbell receiver according to their manual, usually just short press the learning button of sensor or OFF
button of remote control when the doorbell receiver enters into pairing code state.
Remark:
1. The sensor also can choose its individual chime like the doorbell transmitter, if you choose other chime not alarm sound, the receiver will only sound one time
but not 2 minutes.
2. The remote control couldn't choose its individual chime, it only can activate and deactivate the sensors.
3. If you have paired with multiple transmitters and lose one or more of them, it is recommended to follow the operation method described in UNPAIRING
BETWEEN THE DOORBELL RECEIVER AND ALL TRANSMITTERS TOGETHER to unpair all, then relearn the pairing of the remaining transmitters to be used.
RSL884T Remote control (for doorbell series)
Technical data
Model........................................RSL884T (for doorbell series)
Battery type ..............................CR2032
Number of channels .................1 channel (activate button and deactivate button)
Transmission frequency............433.92 MHz
Transmission range .................. 30 m (in open area)
Typically
Transmission power ................<10 dBm
Dimensions (W x H x D) ...........45x 30x 13.5 mm
Key functions
• Two control key: upper = ON/ down = OFF.
• Use the upper key to activate sensor.
• Use the down key to deactivate sensor
The indicator lamp lights up each time a key is pressed.