Intended Use; General Safety Rules - Worcraft PROFESSIONAL AG24-230A Original-Gebrauchsanweisung

Angle grinder

INTENDED USE

The angle grinder is a tool for cutting, scrubbing and brushing metal, concrete or tiles without using water.
The device is not intended for any other types of applications (e.g. grinding with unsuitable grinding tools, grinding with a coolant
solution, grinding or cutting hazardous materials such as asbestos).
The device is intended to be used by do-it-yourselfers. It was not designed for heavy commercial use.
The tool is to be used by adults. Children under the age of 16 may not use the tool except under supervision.
The manufacturer is not liable for damages caused by an improper use or incorrect operation of this device.
TECHNICAL SPECIFICATIONS (see fig. 1)
Model
Voltage
Input power
No load speed
Wheel diameter
Output spindle diameter
Sound pressure level
Soung power level
Vibration level
NOISE/VIBRATION INFORMATION
●
The vibration level given in this information sheet has been measured in accordance with a standardised test given in EN
60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However,if the tool is used for different
applications, with different accessories or insertion tools or is poorly maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when
it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work patterns.
EXPLANATION OF SYMBOLS
Attention!
Read the manual.
Wear eye protection
Risk of cuts!
Wear cut-resistant gloves
Do not use for wet grinding
Suitable for metal
Electrical appliances must not be
disposed of with the domestic waste.
PRODUCT ELEMENTS (see fig. 2)
1
3
5
7
9

GENERAL SAFETY RULES

AG24-230A
230-240VAC 50Hz
2350W
6600rpm
Ø230mm
M14
Spindle
Wrench
Auxiliary handle
Outer flange
Lock off knob
Pull out mains plug immediately, if the mains cable is
damaged, entangled or severed. Always remove the
mains plug before working on the device.
Wear ear protection.
Wear breathing protection
Do not use for side grinding
Do not use defective discs
Wear safety shoes
Protection class II
2 Inner flange
4 Spindle lock
6 Wheel guard
8 Switch trigger