Filling The Magazine; Eu Declaration Of Conformity - BEA PC-340C Bedienungsanleitung

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Turn the tool upside down, press the lock 1 and pull the lower
•
slide 2 backwards. Release the locking button 1, insert the
clamps 3 into the magazine. Then push the lower slide forward
again.
5 Inserting plastic caps
Pull red feeder to the top, turn and lock.
•
Press lever 2 and open cover 3.
•
Insert plastic caps 4 into the magazine from the top. Firmly hold
•
upper disc with the other hand and pull off wire 5. Afterwards close
cover 3 and release feeder 1.
6

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
PC-340C
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 11