Inhaltsverzeichnis
Werbung
Installation
• Connect the electricity plug to any standard power socket
• Press the isolating switch on the back of the shredder
• Make sure the waste bin is fully inserted into the shredder housing or the machine will not operate
Operation
The switch on your Swordfi sh shredder enables you to select one of the following settings:
• AUTO/
Press the power button, the power light will illuminate - with this setting the shredder is automatically started by
inserting paper/credit card into the shred opening.
The shredder is equipped with energy saving technology which will disconnect power after 30 minutes of being idle.
To resume, press the power button.
Press & hold the AUTO/
or shredder shaft
• REV - in the unlikely event of paper jam, the reverse setting can be used to help clear the cutters of paper that has not
passed through properly
Capacity
This Swordfi sh shredder will shred:
• up to 6 sheets of 80gsm paper per pass, with a max width of 220mm.
• Small staples
• single credit card
Continuous shredding should not last more than 10 minutes, after which the shredder should be allowed to cool down for 40
minutes before continuing. In the event of a major paper jam, or if the shredder is used continuously for more than 10 minutes,
the shredder will automatically switch itself off . After an auto power off , switch off the shredder for 40 minutes before turning the
shredder back on.
In case of a minor paper jam:
Grasp the excess paper from the top and pull it out as you press the reverse button.
In case of a major paper jam:
The shredder will automatically switch itself off . After an auto power off , put the switch into the off position for 45 minutes before
turning the shredder back on. Grasp the excess paper from the top and pull it out as you press the reverse button.
Oiling Instructions
• To ensure proper operation and function, periodic oiling of the cutting system is required. Failure to oil your cutting system
could result in reduced sheet capacity performance, excess noise, paper jams and possibly machine failure.
• Oil your cutters every time you empty the bin. (See opposite)
•
Use only oil designed for use in shredders! Never use fl ammable or aerosol lubricants.
•
Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder.
•
On no account should any aerosol product be used on or near this machine, as the propellants may be fl ammable.
Warning
• Do not place fi ngers too close to the feed slot as serious injury may occur
• Always disconnect the power plug before cleaning a Swordfi sh shredder
• Repairs must be carried out by a specialist. There are no user-serviceable parts inside a Swordfi sh shredder. Unauthorised
attempts to service the machine will invalidate the warranty
• Keep the waste bin emptied so that the shredder output is not impeded.
• Swordfi sh shredders should only be used within the defi ned capacity
• Keep all loose articles of clothing, ties, jewellery, long hair or other loose objects away from opening
• Keep children away from the machine. This shredder is not a toy
• Do not pass paper clips or soft plastics through the shredder
• Shredders should be oiled on a regular basis and before any period of intensive shredding
• Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder
•
Follow these operating instruction. Damage caused by misuse will not be covered by warranty
6
button to put the machine in FWD mode - it helps clear loose paper that is still on the blades
www.snopakebrands.com
Operating Instructions
Failure to do so can cause serious damage
Werbung
Inhaltsverzeichnis
