Connection Of Water Drain Hose On Products With Vapour Feature; Adjusting The Stands - Beko B5T68243W2 Bedienungsanleitung

4.3 Connection of water drain hose
on products with vapour feature
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining the
water collected in the water tank
Follow the diagram below to
connect water drain if your drying
NOTICE
machine is equipped with vapour
spray feature.
1
2
C
3
C
4
C
Dryer / User Manual
B A
A
B
A
B
1 Pull hose at the behind of the dryer by hand
in order to disconnect it from where it is
connected. Do not use any tools to remove
the hose.
2 Install the B end of water drain hose
provided with your machine to the end
of the hose you have removed from the
machine.
3 Install the A end of water drain hose
provided with your machine to the location
you have removed the hose on the drying
machine.
4 Fix the C end of the water drain hose to the
waste water drain or the sink directly.
The water discharge hose shall be
fixed at maximum 80 cm height.
Ensure that the water discharge
hose do not get kinked, collapsed
or pressed on between the
discharge and the drying machine.
Hose shall be connected not to
NOTICE
be disconnected from its location.
Leaked water may cause damage.
Do not extend the water drainage
hose.
Check whether the water runs at an
appropriate flow. The drainage line
shall not be closed or clogged.
If an accessory package is provided
with your product, check the
detailed instructions.

4.4 Adjusting the stands

Until the drying
machine stands level
and sturdy, adjust
the stands by turning
them left and right.
49