Battery Specifications - Concept SC2500 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

OPERATING INSTRUCTIONS

ELECTRIC SCOOTER ASSEMBLY

Warning

Always switch off the electric scooter and disconnect the charger from wall socket before assembling or removing accessories!

1. Pull the column under

t h e h a n d l e b a r s a n d

simultaneously press on the

mudguard of the rear wheel.

ELECTRIC SCOOTER ASSEMBLY

2. Put the column upright and

3. Secure the brake lever with

use the locking ring to secure

an M5 Allen key.

the safety lock.

4. Tighten the handlebars

5. Tighten the bolt at the

(pay attention to the direction

column so that it is stationary.

when tightening).

1. Loosen the locking ring.

2. Loosen the safety lock.

3. Lower the column.

4. The hook must fit into

the opening on the rear

mudguard, press to secure it.

HOW TO RIDE THE ELECTRIC SCOOTER

1. Press and hold the On/Off button for 2 seconds.

2. Place one foot on the deck and use the other one to kick off the ground.

3. After you reach a sufficient speed and you feel stable, place your other foot on the deck of the electric scooter.

4. After start, slightly press the accelerator and carefully turn the handlebars to change direction.

5. Press the ACCELERATOR button to accelerate. Be careful and do not ride too fast!

6. Press the brake lever and lightly step on the rear brake to brake.

7. When the electric scooter slows down enough, remove your foot from the deck. After the electric scooter stops

completely, put both your feet on the ground.

RANGE OF THE ELECTRIC SCOOTER

The range of the electric scooter can be affected by several factors, such as the weather, weight, battery charge and state

of the road. These are just main examples, each factor can affect the range and many of them can combine with each

other. Please bear in mind that the total range given in specifications is for reference only. The actual range can vary

greatly. Bear it in mind when using the electric scooter.