Programming Buttons - nedis Zigbee Kurzanleitung

3. Place the battery inside. Observe the plus (+) and
minus (–) marks on the battery and product and
ensure correct placement.
The product automatically switches on.
4. Place the battery cover and rotate A
to close the battery compartment.
5. Fasten A
Connecting to the Zigbee gateway
Make sure the Zigbee gateway is connected to the
Nedis SmartLife app.
For information on how to connect the gateway to the
app, consult the manual of the gateway.
1. Open the Nedis Smartlife app on your phone.
Select the Zigbee gateway to enter the gateway
interface.
2. Tap Add subdevice.
The app asks if the product is in pairing mode. LED
light A
blinks to indicate pairing mode is active.
3
3. Press LED already Blink if A
If A
3 is not blinking, activate the pairing mode
4
manually. Press and hold the reset button A
5 seconds.
The status indicator LED A
indicate pairing mode is active.
After a few seconds, the product appears on the
interface.
4. Rename the product by tapping above the current
name.
5. Tap Done to confirm and save the connection.

Programming buttons

The product has three commands: single tap, double
tap and long press. Each command can be assigned to
a different action for a linked Nedis SmartLife product.
1. Open the Nedis Smartlife app on your phone.
2. Tap Smart scenes at the bottom of the home
screen.
by screwing A
2 1 back in.
3 is blinking.
3 starts blinking to
6
clockwise
2
for
4