Technical Data; What To Do If - Centronic SWC441 Montage- Und Betriebsanleitung

Nominal voltage
Type of battery
Protection class
Permissible surrounding temperature
Radio frequency
Problem
Drive is ot functioning,
transmission control
light is not lit.
Drive is not function-
ing, transmission
control light is lit.
Transmission control
light is flashing.
Automatic control
commands are not
executed.
The system is not
extended automatically
when the sliding switch
is set to "S".
The system does not
extended manually
when the sliding switch
is set to "H" or "S".

Technical data

What to do if ...?

Cause
1. Batteries are dead.
2. Batteries are incor-
rectly inserted.
1. Receiver outside the
radio range.
2. Transmitter is not
programmed in the
receiver.
Battery power is low.
1. Sliding switch not in the
"H" position.
2. The automatic sun
protection function
was interrupted by a
manual command.
1. Sunlight intensity is
below the threshold
value.
2. Wind speed exceeds
threshold value.
Wind speed exceeds
threshold value.
3 V DC
LR 03 (AAA)
IP 20
-10 to +55 °C
868.3 MHz
Remedy
1. Insert new batteries.
2. Insert batteries cor-
rectly.
1. Reduce distance to
the receiver.
2. Programme transmit-
ter.
Replace batteries.
1. Set sliding switch to the
"S" position.
2. Turn the sliding switch
from "S" to "H" and
back to "S".
1. Adjust sun threshold
value.
2. Wait until wind abates.
Wait until wind abates.
de
en
fr
nl
21