MYPV P1 Kurzanleitung

EN
Digital Meter P1 Interface
for AC•THOR / AC•THOR 9s / AC ELWA 2
Quick Start Guide
NOTE: The Digital Meter P1 Interface can be used with
AC•THOR from firmware version a0020300 or higher! To
install this firmware on already delivered devices, please
send us the 16-digit serial number to
support@my-pv.com.
Intended Use
The Digital Meter P1 interface is exclusively designed for
operation with AC•THOR, AC•THOR 9s or AC ELWA 2. It
connects the displayed utility meter with the Modbus
RTU gateway of the my-PV device. Thus the excess power
info in a photovoltaic system can be received and used
without any additional meter.
The Digital Meter P1 interface will be damaged by any
wrong usage.
Before commissioning, it is essential that you read the
assembly instructions that accompany the my-PV device,
as well as the operation manual available online.
Find the operation manual here.
AC•THOR / AC•THOR 9s AC ELWA 2
Scope of delivery
• Digital Meter P1 Interface
• 120 Ohm resistor
Safety indication
Always comply with local regulations for mounting and
connection.
Any damage caused by ignoring the installation and user
manual is not covered by the manufacturer's warranty.
Exemption of Warranty and Liability
Any warranty and Liability is excluded for:
• Injury to person and/or damage to property caused by
unintended use or in disregard of safety-and user
instructions
• Consequential damages
• Unauthorized modification, disassembling or other
conversion of the device.
Assembly
Plug the RJ12 socket of the interface into the right port
of the displayed utility meter (P1).
Install a cable with 3 wires (shielded) from the terminal
block on the interface to the Modbus RTU gateway on the
my-PV device. Maximum cable length is 1,000 m
Install the 120 Ohm resistor between A and B at the my-
PV side of the cable.
AC•THOR / AC•THOR 9s AC ELWA 2
Use shielded twisted pair wire for communication!
Setting for Communication
Check if the data output of the meter data needs
to be activated by your grid operator!
At step 3 of the commissioning you have to choose a
signal source. Select "Digital Meter P1" at this step.
The signal source can also be adjusted anytime later on
the display under "Settings" or on the Web-Interface if
the my-PV device has an Ethernet connection with a
router.
Troubleshooting
The device does not contain any user serviceable parts.
Call your installer for service.
Disposal of waste
Keep the packaging material or dispose it
properly.
Dispose the product at the end of its service
life in accordance with the applicable regulatory
requirement.
EU Declaration of Conformity
You can find them at any time on www.my-pv.com
Digital Meter P1 Interface Quick Start Guide,
230628