Warnings And Symbols - hymer 817704 Aufbau- Und Verwendungsanleitung

1. Contents
A. Confi guration table
B. Graphic display of components
C. Assembly and dismantling
D. Ballasting
E. Assembly of height offset
1. Contents

2. Warnings and symbols

3. About this document
4. Intended use
5. Scope of delivery
2. Warnings and symbols
2.1 Warnings
Warnings are used in this document to warn you of personal injury
and damage to assets.
▪ Always read and observe these warnings.
▪ Observe all measures marked by the warning symbol and warning
word.
WARNING!
Failure to comply may result in serious injury or damage.
NOTE!
i
Indicates important information.
2.2 Symbols according to EN 1004
Read the assembly and use instructions carefully
and keep in a safe place.
Do not assemble or use at wind speeds of over
12 m/s (Beaufort Scale 6).
The product must be aligned vertically by means of
levelling spindles (if available).
Maximum inclination may not exceed 1 %.
2022-04 0095855 8177 TNR
6. Declaration
7. General information
8. Assembly, modifi cation and dismantling
9. Stability
10. Use and moving
11. Other safety instructions
12. Checks, care and maintenance
13. Transport and storage
14. Packaging and disposal
15. Checklist and release form
The vertical distance between:
▪ platforms may be maximum 2.25 m.
▪ installation area and the fi rst platform may be
maximum 3.40 m.
Do not stand on an unsecured platform. Fit side
protection before accessing the platform.
▪ Use temporary guardrails or
▪ carry out assembly in seated position from the
access hatch.
EN
19
EN 1004-2 - en