Cleaning And Maintenance - prime3 SFH81 Bedienungsanleitung

SFH81
Conformity
Hereby, 2N-Everpol Sp. z o.o., declares that this equipment is in compliance with the essential
requirement and other relevant provisions of Directive 2014/53/EU. Declaration of conformity can
be obtained from the product page at www.prime3.eu. Responsible party: 2N-Everpol Sp.z o.o.,
Puławska 403A, 02-801 Warsaw, Poland, Phone: +48 22 688 08 33, E-mail: info@prime3.eu
When this crossed-out bin symbol is attached to a product it means that the product is covered by
the European Directive 2002/96/EC. Please inform yourself about the local separate collection
system for electrical and electronic products. Please act according to your local rules and do not
dispose of your old products with your normal household waste. Correct disposal of your old
product helps to prevent potential negative consequences for the environment and human health.
The device is equipped with batteries covered by the European Directive 2006/66/EC. Do not
dispose of batteries with household waste. Please refer to your local regulations for separate
collection of batteries, as proper disposal will prevent potential negative consequences for the
environment and human health.
TECHNICAL SPECIFICATIONS OF THE APPLIANCE
Input voltage: 220-240V~50Hz
Output power: 1500W
1. On/Off knob.
2. Thermostat regulation knob.
3. LED indicator.
SAFETY FEATURES
1. In case of overheating, thermostat will turn off the device. Unplug the heater and wait until it cools down.
Find the cause of overheating. Heater can be plugged in and switched back on after cooling down.
2. If the device tips over, a safety switch will automatically switch it off. Put it back in vertical position in order
to switch it on.
Use
Fan heater has 3 settings:
1. Cool blow (only fan is operating)
2. 750W (medium heat)
3. 1500W (maximum heat)
Thermostat allows adjusting the temperature of heating. Fan heater will maintain the chosen temperature.

CLEANING AND MAINTENANCE

Before cleaning the heater make sure that it has been switched off, unplugged from the power socket. Make
sure the device has cooled down sufficiently.
Air inlets and outlets should be free of dust. Clean with dump cloth and wipe dry.
6