Clean Air Optima CA-904G Gebrauchsanweisung Seite 9

3. In operating condition, press the
power. By pressing the key again, the PTC will switch back to low heating power.
a) If working at low heating power: the low heating power icon
power icon is off).
b) If working at high heating power: the high heating power icon
starts after 10 seconds).
4. In operating condition, press the
By pressing the key again, the fan switches back to low power.
a) When working at low fan speed: the low fan power icon
b) When working at high fan speed: the high fan power icon
5. In operating mode, you can press the
a) Press the Swing key: the device will oscillate, the
b) Press the Swing key again: the device will stop oscillating, the
Note:
In warm airflow mode the PTC stops working when the room temperature is higher than
the set temperature. The fan stops working after 10 seconds. During that time, the swing
function is not available.
6. In operating condition, press the
a) Go to the timer setting mode, press the
every 0.5 seconds. During this time-frame, press the
(0-12 hours), with each key press the time will be added by 1 hour.
By pressing and holding the
b) If no keys are pressed within 5 seconds (except for
show the room temperature.
c) Press the timer key to see the set time. If the value shows a number except for -0-, the
timer will start timing (not shown), if the timer reaches value -0-, then the device will
turn off at once.
d) If the value shows -0- in timer setting, then this means no time is set, the time icon will
be off, the LED display will show the current room temperature.
key to shift PTC from low heating power to high heating
key to shift from low fan power to high fan power.
key to make the device oscillate or not.
key to set the timer.
key, the LED time icon
or keys, the time can be set faster.
lights up (the high heating
lights up. (high heating
lights up.
lights up.
icon lights up.
icon will be off.
lights up and blinks
or the key to set the timer
and ), the LED indicator will
9