HAGOR CON-Line W Lift 55 - 75 Installationsanleitung Seite 25

Manual Lift system | ENGLISH
1.) Adjusting the height. Press + or - button until the preferred height is reached.
2.) Setting the Memory position. Adjust the desk to the desired height. Press preferred memory button (1, 2, 3, 4),
with either + or - for 2 seconds, once the display shows P1 or P2 or P3 or P4. Press (and hold) button 1, 2, 3 or
4 to move the screen to the memorized position.
3.) Setting the upper and lower height limit
A. Setting the upper height limit:
(1) Adjust the screen to the preferred upper height limit.
(2) Press + and - buttons together for less than 3 seconds, holding + and release - button. (Note 2)
(3) Re-press - for more than 3 times at a slow pace.
(4) A beeping sound will notify you that the process has been completed.
B. Disable the upper height limit:
(1) Move the screen to the upper height limit being set.
(2) Repeat instructions #2~4 above to disable the upper limit setting.
C. Setting the lower height limit:
(1) Adjust the screen to the preferred lower height limit.
(2) Press + and - buttons together for less than 3 seconds, holding - and release + button. (Note 3)
(3) Re-press + for more than 3 times at a slow pace.
(4) A beeping sound will notify you that the process has been completed.
D. Disable the lower height limit:
(1) Move the screen to the lower height limit being set.
(2) Repeat instructions #2~4 above to disable the lower limit setting.
4.) Presetting the Desk Starting Height
(1) Press button until the desk reaches its lowest position and then release button. Re-press button
again for 5 seconds and the digital display will flash for 10 seconds.
(2) Adjust the starting height number with the + or - button.
(3) After 10 seconds, the display will stop flashing and this will confirm that you have successfully set the
starting height.
5.) Switching Metric and Imperial Unit
(1) Press memory buttons 1, 2 and 4 for 5 seconds.
(2) The digital display will show "C-I". If no further instruction is input within 5 seconds,
the system reverts to the normal operation mode.
How to choose a metric unit:
Press button 2, the digital display will show "C" to stand for centimeter.
How to choose an imperial unit:
Press button 3, the digital display will show "I" to stand for inch.
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: info@hagor.de