Explanation Of Symbols - Heras Condor Installationshandbuch

Explanation of symbols

Use an open-end wrench.
The number specifies the
insertion size in mm.
Use a hammer.
Use a screwdriver.
The symbol specifies the type of
screw. The number specifies the
15
size of the screw.
Use a electric screwdriver.
The symbol specifies the type of
screw. The number specifies the
15
size of the screw.
Use a drill.
The number specifies the drill bit
diameter in mm.
Ensure that the specified parts
are level.
Use a brush.
Do not perform the work on
your own.
Use a lifting tool/hoisting
system.
Use a pump.
Use IP4 bit.
Condor
ins
5
Check the distance.
Indoors
Outdoors.
Dig a hole.
Use concrete
Follow the instructions on the
packaging
This step is optional.
Refer to a different manual.
manual
Page reference
Specifies a reference to a
page.
EN EN