Vaxcel Dualux Omega 3L Installations- Und Bedienungsanleitung

ASSEMBLY AND INSTALLATION
E3893
WARNING:
Important to Know:
1. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
2. This fixture requires a 220-240V, 50 Hz
power source.
Maximum Wattage: 34 W
Working Temperature Range: -4
Note: Fixture can be wall mounted or eave mounted.
Wall Mounted
Read notes section on last page for additional information about mounting location of fixture.
Light fixture and sensor should be mounted as shown above when installed (depending upon type of installation)
Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for
proper operation and to avoid the risk of electrical shock.
For eave mounted only:
Swing the sensor head towards the mounting bracket.
Installing Steps
1. Unscrew the fixture mounting screw in order to remove the mounting bracket.
2. Using the mounting bracket of the light as a template, mark and drill the holes on the mounting surface in the desired
location with a 3/16 in. (5mm) drill bit and insert the anchors.
3. Place the mounting bracket into position and secure with dry wall screws. Insert the plastic plug to the dry wall
screws. (Fig.1)
4. Run the cables through the grommet in the back plate and leave enough length to terminate.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
o o
F ~ 113 F
Mounting Bracket
Controls
Features:
1. Energy saving LED fixture.
2. Motion sensor: turns light ON automatically when
motion is detected and turns light OFF automatically
when motion stops.
3. Photocell keeps the light OFF during daylight hours.
4. Different operating modes possible depending
on user needs.
Rotate the sensor head clockwise 180° so the controls face down.
Page 1 / 4
Eave Mounted
Controls
190220
Controls