Cold Lamination - Olymp A 235 Plus Bedienungsanleitung

Laminator A 235 Plus

Cold Lamination

CAUTION!
• Danger of burns due to hot laminating foil!
When ejected after hot laminating, the laminating foil is very hot.
Take particular care when handling hot laminating foils.
The laminator automatically draws in the laminating foil and discharges it on the
output side.
Cold Lamination
For cold lamination, the laminating foil is coated with a special adhesive. Unlike
hot lamination, cold lamination bonds the foil by means of pressure, not heat.
Cold lamination is suitable for non-permanent sealing. The cold lamination foil can
usually be removed from the laminated material without leaving any residues.
1. Stand the laminator securely on a level, horizontal surface.
Make sure the on/off switch is switched to OFF before plugging the lamina­
tor into a power socket.
2. Plug the laminator cable into an available power socket.
3. Switch the ON/OFF switch to ON and the COLD/HOT lamination switch to
COLD. The POWER and READY indicator lamps light up.
4. The drive motor for the rollers starts up. The laminator is ready for operation.
If you have used the laminator for hot lamination shortly before you want to
cold-laminate, let it cool down for around 30 minutes.
5. Remove the protective foil from the lamination foil.
6. Place the material to be laminated inside the laminating foil. For an optimal
lamination result, leave a space of 3 to 5 mm between the edges of the docu­
ment and edges of the foil on all sides.
If the material to be laminated is not in a standard format, also place an
insert inside the laminating foil that corresponds with the format of the lami­
nating foil. Place the material to be laminated at the front edge of the
closed end of the laminating foil.
7. Feed the prepared laminating foil with the closed side first, keeping it straight,
into the infeed of the laminator.
The laminator automatically draws in the laminating foil and discharges it on the
output side.
18